Reloop DIGITAL JOCKEY INTERFACE EDITION - Manual (Page 53)

PI: Enable auto cue
If this function is enabled a cue point will be set automatically at the first beat of
a track.
PII: Save data when program exits
If this function is enabled your data, such as cue points, samples or fader and
pitch values, will be saved when exiting the software.
PIII / PIV: Replay gain
With this knob -PIV- you can adjust the pre-amplification level for example for an
optionally connected turntable. The adjustable values go from 80 – 100 dB.
Activate this function by check marking the field -PIII-.
NOTE!
If this function is enabled the Attack software will automatically analyze
and save the track's gain level when playing it for the first time. This way
audio material with differing gain values is automatically matched.
PV: Loop/sampler buffer length
With the knob -PV- you can adjust the sampler buffer length. The value is
adjustable from 8 – 30 seconds.
PVI: Auto beat sync
Here the span of time can be adjusted from 0 – 200 msec. if you want the beat
to be synchronized. If the value is at “0” the beat will be synchronized without
time dely.
• Audio Device
You have already asigned the correct ASIO audio adjustments in the first steps.
Please also observe chapter 1.4 paragraph “Audio device”
To complete the Instruction, below you will finf the possible DirectSound options:
53
ENGLISH
P XI
P VIII
P XII
P XIII
P XIV
P XV
P XVII
P XVIII
P XIX
P XVI
P X
P IX
P VII