RCBS Pro 2000 Progressive Reloading Press - Manual (Page 4)

- 4 -
PRESS ASSEMBLY
1. Select a solid bench on which to
mount the Pro 2000 Press. You
must use the two slots for
mounting holes (use casting as a
template). For benches with
limited space, or to increase the
rigidity of your bench, try our
Accessory Base Plate (pn
09280), available through your
local dealer. See photo below.
RCBS Accessory Base Plate
2. Select an area with approximately
one foot of clearance on each side
of the Pro 2000 Press. Install with
two 3/8" bolts, or four ¼” bolts,
length to be determined by the
thickness of your reloading bench
(mounting hardware not included).
Photo 1
3. Install the Pro 2000 handle and
tighten the handle nut. See photo
2
Photo 2