Kino Flo VistaBeam 600/300 DMX - Manual (Page 11)

11
Power & Fuse Requirements
POWER
Provide 120VAC or 230VAC depending on model.
Do not dim the fixture through a dimming circuit.
If powering the fixtures through a dimming board,
set the dimmer profile to non-dim.
FUSE
Fuse provides circuit protection. Note: If Fuse is
“blown” or “open”, replace with same type of fuse
rating as marked.
Load Considerations:
The Kino Flo ballasts used in the VistaBeam are not power factor corrected.
They will draw double the current on the neutral from what is being drawn on the
two hot legs. On large installations it may be necessary to double your neutral run
so as not to exceed your cable capacity.