Kessler CAMERA SLIDERS: Parallax Installation Guide - Manual (Page 2)

Step 3
Secure Parallax rail to slider center mount using included 1/4”-20 countersunk screws
Fig. D
Step 2
Use 2 included 1/4”-20 custom countersunk screws to secure Parallax rail to slider
channels using larger (3/8”-16) screw holes with included 5/32” allen key
Fig. C Fig. B
Step 1c
This step is for 2’ (Traveler Length) aluminum sliders only.
Measure from the center of each 3/8”-16 hole as shown.
If 18”, skip to Step 2. If 17”, proceed with Step 1d and adjust arms.
Step 1d
Move both left and right arms to inside slots by unscrewing the lever to match with
proper holes on slider.
slot