HF scientific Micro200BW Turbidimeter - 0 -1000 NTU User Manual
Page 59

MICRO 200 BW 0 - 1000 NTU (5/05) Rev. 3.1
Date: August 3, 2004
Revision: 10
MATERIAL SAFETY DATA SHEET
HF scientific, inc.
24 Hour Emergency
3170 Metro Parkway
Telephone Number
Fort Myers, FL 33916-7597
CHEMTREC
(239)
337-2116
1-800-424-9300
Mon-Fri 8:00 am - 4:30 pm
SECTION 1 PRODUCT IDENTIFICATION
PRODUCT NAME: 100 %T STANDARD SOLUTION, 0.02 NTU PRIME
TIME STANDARD, REFERENCE STANDARD, 0.02 NTU 250 ML
PRIMARY STANDARD, and 0.02 NTU 1GALLON PRIMARY
STANDARD, WATER - INCLUDING H2O PRIME TIME STANDARD.
CATALOG NUMBER:
HF scientific, inc.
14246/19199/19323/50047/60002/70908
U. S. Filter/Wallace & Tiernan:
AAC1556/AAC6608
CHEMICAL FAMILY: Not applicable
SYNONYMS: None
FORMULA: Turbidity free water (CAS # 7732-18-5), Preservative
SECTION 2 HAZARDOUS INGREDIENTS
No hazardous ingredients greater than or equal to 1%
No carcinogen greater than or equal to 0.1%
SECTION 3 PHYSICAL DATA
Boiling Point(F): Approximately 212 deg F (100 deg C)
Solubility in Water: Miscible
Vapor Pressure (mm Hg): Not determined
Appearance and Odor: Clear and colorless; no odor.
pH : 1.1 - 2.0 at 25 deg C
Vapor Density(AIR=1): Not determined
Specific Gravity (H
2
O=1): Approximately 1
Melting Point: Approximately 32 deg C (0 deg C)
Evaporation Rate: Not determined
Percent Volatile by Volume: Not determined
SECTION 4 FIRE AND EXPLOSION HAZARD DATA
Flash Point: Not Flammable
Flammable Limits: Not determined
Fire Extinguishing Media: Suitable to cause of fire
Fire Fighting Procedures: Suitable to cause of fire
Unusual Fire And Explosive Hazards: None
SECTION 5 HEALTH EFFECTS AND FIRST AID
Route(s) of Entry: Inhalation? No Skin? Yes Ingestion? Yes
Effects of Overexposure: Irritation of the eyes, mucous membranes and
skin could occur.
Carcinogenicity: NTP? IARC MONOGRAPHS? OSHA REGULATED?
Not a carcinogen.
Signs and Symptoms of Exposure: Burning or irritation of the exposed
area.
Medical Conditions Generally Aggravated by Exposure: None found
Emergency First Aid Procedures:
Skin: Wash with plenty of water for 15 minutes. Call physician if irritation
occurs.
Eyes: Flush eyes with plenty of water for 15 minutes. Call physician.
Ingestion: Give large quantities of water. Do not induce vomiting. Never
give anything by mouth to an unconscious person. Call physician.
Inhalation: Remove to fresh air. If breathing has stopped, give artificial
respiration. Call physician immediately.
SECTION 6 REACTIVITY DATA
Stability: Stable
Conditions to Avoid: Organic matter, chlorates, active metals
Incompatibilities (Materials to Avoid): Organic matter, chlorates, active
metals
Hazardous Decomposition Products: Toxic SOx fumes
Hazardous Polymerization: Will not occur
SECTION 7 SAFE HANDLING AND USE
Steps to be Taken in Case Material is Released or Spilled: Neutralize
with soda ash. Absorb with paper.
Waste Disposal Method: DISPOSE OF IN ACCORDANCE WITH ALL
APPLICABLE FEDERAL, STATE AND LOCAL ENVIRONMENTAL
REGULATIONS.
Precautions to be Taken in Handling and Storage: Avoid contact with
skin, eyes and clothing. Store tightly closed in a cool, dry place.
Other Precautions: Do not open vial to preserve low turbidity of
standard.
SECTION 8 CONTROL MEASURES
Respiratory Protection: None required in normal use.
Ventilation: General mechanical ventilation satisfactory in normal use.
Skin Protection: Rubber gloves
Eye Protection: Safety goggles
Other Protective Measures: None
Work/Hygenic Practices: Wash well if contact occurs
NO GUARANTEE IS MADE AS TO THE ACCURACY OF ANY DATA
OR STATEMENT CONTAINED HEREIN. WHILE THIS MATERIAL IS
FURNISHED IN GOOD FAITH, NO WARRANTY EXPRESS OR
IMPLIED, OR MERCHANTABILITY, FITNESS OR OTHERWISE IS
MADE. THIS MATERIAL IS OFFERED ONLY FOR YOUR
CONSIDERATION, INVESTIGATION AND VERIFICATION AND HF
SCIENTIFIC INC., INCLUDING ITS DIVISIONS, AFFILIATES AND
SUBSIDIARIES, SHALL NOT IN ANY EVENT BE LIABLE FOR
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES IN
CONNECTION WITH ITS PUBLICATION. LIKEWISE, NO STATEMENT
MADE HEREIN SHALL BE CONSTRUED AS A PERMISSION OR
RECOMMENDATION FOR THE USE OF ANY PRODUCTION IN A
MANNER THAT MIGHT INFRINGE EXISTING PATENT.