HF scientific Micro200BW Turbidimeter - 0 -1000 NTU - Manual (Page 27)

Page 13
MICRO 200 BW 0 - 1000 NTU (5/05)
Rev. 3.1
3. Main Menu
This is the main menu. It is the starting point for all sub-menu selections. Shown below are all function key selections and their
purpose.
Selection Options:
F1:
Changes screen to ALARM MENU
Select this option to set the value at which the alarm contacts will change for Alarm #1 & Alarm #2.
F2: Changes screen to DISPLAY PARAMETERS MENU
Select this option to:
Set upper limit
Set lower limit
Select time base
Set average
Select D to A
Set digit suppression
F3: Changes screen to UTILITY MENU
Select this option to:
Set screen brightness
Clear graph history
Set time & date
Calibrate & Adjust offset
Set up serial port parameters
Disable/Enable & Set access code
Run self test diagnostics
F4: Changes screen to TURBIDITY DISPLAY
Select this option to display current turbidity and graph turbidity history.
F5: Changes screen to BACKWASH DISPLAY
Select this option to display and graph a backwash cycle if backwash option is connected.
F2
F3
ALARM
F5 F4
MENU
F1
Main Menu
Alarms
Display Parameters
Utility
Turbidity Backwash
Ver: M200BW-7B210ME6