E-flite Alpha 450 Sport PNP - Manual (Page 9)

9 E-flite Alpha Sport 450 PNP Assembly Manual
 5. Make sure the elevator trim and stick have been
centered at the transmitter. Use a ruler to make sure
the elevator is aligned with the stabilizer. Tighten
the screw using a #1 Phillips screwdriver at the
elevator servo to secure the elevator pushrod wire
to the connector at the servo.
Use threadlock on all metal-to-metal fasteners
to keep them from vibrating loose.
 6. Unplug the motor battery and then turn
off the transmitter.
Attaching the Wing and
Centering the Ailerons
Required Parts
Fuselage assembly Wing panel (right and left)
Wing tube
#4 steel washer (2)
Wing bolt plate Motor battery (charged)
Transmitter
4-40 x 3/4-inch socket head bolt (2)
Required Tools and Adhesives
Ruler Phillips screwdriver: #0
Threadlock
Hex wrench or ball driver: 3/32-inch
Optional Tools and Adhesives
6-minute epoxy Paper towel
Rubbing alcohol Epoxy brush
Mixing stick Mixing cup
Low-tack tape
 1. Slide the wing tube in the socket in the root end
of the right wing. The tube will slide in easily. Do not
force the wing tube in farther than it can easily slide.
 2. Slide the remaining wing panel on the wing
tube. The pin at the rear will fit into the hole in the
opposite wing panel.
 3. The wing panels will fit tightly together. This is
necessary for the wing to fit on the fuselage.