E-flite Alpha 450 Sport PNP - Manual (Page 7)

7 E-flite Alpha Sport 450 PNP Assembly Manual
Installing the Motor Battery
Required Parts
Fuselage assembly Motor battery (charged)
Hook and loop strap Hook and loop tape
 1. Lift up at the rear of the battery hatch and slide
it to the rear of the fuselage to remove. Set the
battery hatch aside to install the motor battery.
 2. Slip the hook and loop strap through the holes
in the battery tray as shown. Make sure the softer
loop tape is facing out or you will not be able to
secure the battery with the strap.
When installing the hook and loop strap,
make sure the wire to the nose gear does not
interfere with the strap. The wire must remain
free to move when the strap is installed.
 3. Take the connector from the speed control for the
battery and insert it though the hole in the battery
tray into the battery compartment.
 4. Use the hook and loop strap to secure the
motor battery in the battery compartment. If the
motor battery slides forward or rearward in the
compartment, use a piece of hook and loop tape
between the motor battery and battery tray to keep
it from moving.
When balancing your model, you will be
required to move the battery forward or
aft to achieve the best CG for flight.