E-flite Alpha 450 Sport PNP - Manual (Page 17)

17 E-flite Alpha Sport 450 PNP Assembly Manual
 B. Slide the propeller on the threaded shaft of
the spinner adapter. Make sure the numbers
embossed on the propeller are facing away from
the spinner backplate.
 C. Slide the washer included with the spinner
assembly on the threaded shaft. The nut included
with the spinner assemble is then threaded on the
shaft. Only thread the nut 2–3 turns: it does not
need to be tightened at this time.
 D. Slide the assembly on the motor shaft. It should
fit snugly on the shaft. If it seems to be excessivly
loose, you have used the wrong motor adapter
and need to return to Step B and swap the adapter
out with the remaining adapter included with the
spinner assembly.
 E. Use an adjustable wrench or 10mm open-end
wrench to tighten the nut. This will secure the
adapter and propeller to the motor shaft.
 F. Place the spinner cone on the backlplate. Position
the spinner cone so the openings in the spinner
cone are not in contact with the propeller. Use the
screw included with the spinner assembly and a
3/32-inch hex wrench or ball driver to tighten the
screw to secure the spinner cone in position.