E-flite Alpha 450 Sport PNP - Manual (Page 11)

11 E-flite Alpha Sport 450 PNP Assembly Manual
 6. Position the wing bolt plate as shown in the
photo. The rounded end will face to the front of the
airframe. The holes in the plate will align with the
holes in the wing.
 7. Slide a #4 steel washer on a 4-40 x 3/4-inch
socket head bolt. Then slide the bolt through the
hole in the wing bolt plate and wing. You will
use two steel washers and two bolts to secure the
wing to the fuselage. Blind nuts are installed in the
fuselage to accept the bolts. Use a 3/32-inch hex
wrench or ball driver to tighten the wing bolts that
secure the wing to the fuselage.
 8. Move the switch on your transmitter to the On
position. Make sure the throttle stick is toward the
bottom of the transmitter, or low throttle position.
Connect the leads for the battery and motor.
Note: It may be necessary to remove the
servo arm when centering the servo.
 9. Loosen the screw that secures the aileron
pushrod wire to the servo using a #1 Phillips
screwdriver. Do this for both ailerons.
 10. Make sure the aileron stick and trim are
centered at the transmitter. Use a ruler to align
the aileron with the bottom of the wing. Use a
#1 Phillips screwdriver to tighten the screw at
the aileron servo connector to secure the aileron
pushrod wire. Do this for both ailerons.
Use threadlock on all metal-to-metal fasteners
to keep them from vibrating loose.
 11. Unplug the motor battery and then turn off the
transmitter if you are not continuing to the next
section of this manual.