E-flite Alpha 450 Sport PNP - Manual (Page 6)

6 E-flite Alpha Sport 450 PNP Assembly Manual
 10. Slide two 3mm steel washers on the threaded
rods from the rudder assembly. The rudder
assembly is then secured using two 3mm locknuts.
Use a 5.5mm nut driver and a #2 Phillips
screwdriver to tighten the nuts. Make sure not to
over-tighten the nuts and damage the fuselage.
Installing the Receiver
Required Parts
Fuselage assembly Receiver
Y-harness
Hook and loop tape
Required Tools and Adhesives
Scissors Clear tape
 1. Plug the leads from the rudder servo, elevator
servo and speed control into the appropriate ports
of the receiver. Plug the Y-harness into the aileron
port of the receiver.
 2. Use scissors to cut a small piece of hook and
loop tape. Remove the backing and apply the hook
and loop to the bottom of the receiver.
 3. Remove the remaining backing from the hook
and loop tape. Position the receiver in the fuselage
as shown.
 4. Use clear tape to secure the longer antenna
wire from the receiver under the wing mounting
plate and to the side of the fuselage to keep it from
interfering with the operation of the servos and to
provide the best reception for your radio system.