E-flite Alpha 450 Sport PNP - Manual (Page 5)

5 E-flite Alpha Sport 450 PNP Assembly Manual
 4. Insert the 3mm x 50mm machine bolt through
the hole in the stabilizer that is the closest to the
rear of the aircraft. The bolt will pass through the
fuselage through holes that have been previously
made in the fuselage for this purpose.
 5. Slide a 3mm steel washer on the bolt and then
thread a 3mm locknut on the bolt. Leave the nut
slightly loose at this time.
 6. Insert the bend in the rudder pushrod wire into
the outer hole of the rudder control horn.
 7. Rotate the rudder into position as shown.
 8. Insert the threaded rods from the rudder through
the two forward holes in the stabilizer and into the
holes in the fuselage.
 9. Slide the rudder assembly into position, making
sure it is fully seated on the fuselage as shown.