E-flite Super Airliner DF ARF - Manual (Page 3)

Introduction
Thank you for your purchase of the Super Airliner from
E-flite bringing you, the modeler, the jet experience without
the hassle of glow powered ducted fans or the cost of
turbine engines. We selected a twin airliner design for the
enlarged wing area, and multiple engines for more power
in flight. The model is molded from EPS foam for durability
and ease of repair should the need arise. All of our Airliners
have weighed in at 3
1 /
4
pounds, ready for flight, using two
Thunder Power 2100 mAh 11.1V Li-Po batteries. We use the
BEC function of both speed controllers to save weight and
ensure trouble-free radio operation.
The Super Airliner is designed for use from hard surface
runways or very smooth grass fields. It was not designed
for rough grass fields and has not been tested for such
operations. The tires are small and work very well from hard
surface runways. Please take note of the flight control surface
throws in the back of the manual. These are correct and
you will need this amount of throw to fly this model. Trying
anything less will diminish your chances of success. Ducted
fan aircraft do not have the prop blast feature associated
with propeller driven aircraft over the flight controls. For this
reason, you need more control throw than you would need
on a propeller-driven model.
Flight times of 8 minutes or longer are the normal procedure
with the Airliner using the equipment specified in this manual.
We hope you enjoy your experience with this new offering
from E-flite. So start building and set the date for your first
takeoff with E-flite Air!
Required Radio Equipment
Radio System
You will need a minimum 4-channel transmitter, crystal, one
standard BB servo, and four sub-micro servos. If you are
using an existing transmitter, just purchase the other required
equipment separately.
Purchase Separately
JSP30600 RS600 6-Channel Receiver w/o Crystal
JRPXFR** FM Receiver Crystal
JSP20060 ST47BB Servo
JSP98110 6" Servo Extension (2)
JSP98030 12" Servo Extension (3)
JSP98020 6" Y-Harness (3)
EFLRS75 S75 Sub-Micro Servo (4)