E-flite Super Airliner DF ARF - Manual (Page 10)

  2. Enlarge the outer hole in the servo arm using
a 5/64" (2mm) drill.
  3. Slide the pushrod connector into the hole.
Secure the connector using a 2mm nut.
Hint:.Use.threadlock.or.a.drop.of.thin.CA.on.
the.nut.to.prevent.it.from.loosening.during.flight.
  4. Mix a small drop of 6-minute epoxy and
apply it onto the servo pocket. Press the servo into
the pocket and allow the epoxy to cure before
continuing to the next step.
10