E-flite Super Airliner DF ARF - Manual (Page 23)

Elevator Servo Installation
Required Parts
• Fuselage • Pushrod connector assembly (2)
• Servo • Y-harness
• Receiver • Hook and loop
Required Tools and Adhesives
• Drill • Drill bit: 5/64" (2mm)
• Threadlock • Medium CA
• 1.5mm hex wrench
 1. Use hook and loop to attach the receiver inside
the fuselage. Plug a 6" Y-harness into the rudder
channel of the receiver. Plug the steering servo
into one lead from the Y-harness.
Note:.At.this.time.there.will.be.a.6".Y-harness.
plugged.into.the.rudder,.throttle.and.aileron.
channels.of.the.receiver.
23