E-flite Super Airliner DF ARF - Manual (Page 28)

 4. Slide the pushrod support onto the pushrod. Use
medium CA to glue the tube in position against
the rear wing bolt plate and the servo tray. With
the pushrod wire pulled partially out of the tube,
trim the pushrod tube around 1/4" (6mm) in front
of the pushrod tube support.
 5. Slide the pushrod wire through the pushrod
connector. Center the rudder and rudder servo.
Secure the wire using a 3mm setscrew.
 6. Use medium CA to glue the pushrod tube to the
pushrod tube support.
 7. Complete the radio installation by routing the
antenna wire to the rear of the fuselage. Do not
cut the antenna as it will greatly reduce the range
of your radio system.
28