E-flite Tensor 4D ARF - Manual (Page 33)

33
 3. Mount the receiver in an inconspicuous location
on the fuselage spine using hook and loop or
double-sided tape. Plug the elevator, rudder
and aileron servos into the receiver. Route the
antenna wire to the bottom of the fin.
 4. Solder any necessary connectors to your
speed control. Cut a small hole in the fuselage
spine to pass the battery lead through. Connect
the speed control to the receiver and motor.
Attach the speed control to the fuselage spine
using hook and loop or double-sided tape. Tie
any loose wires so there is no chance they can
enter into the spinning propeller.