E-flite Tensor 4D ARF - Manual (Page 26)

26
Aileron Servo Installation
Required Parts
Assembled airframe
Micro control connector (4)
Control connector backplate (4)
2mm x 4mm screw (4)
Micro control horn (6)
Micro control horn backplate (6)
.065" x 7" carbon pushrod (2)
1/32" x 2" pushrod end (4)
1/32" x 3
1
/
8
" pushrod (2)
Micro pushrod keeper (2)
Required Tools and Adhesives
Foam-safe CA T-Pin
Drill 1/16" drill bit
Razor saw
 1. Position the aileron servo on the bottom of the
bottom wing so the output shaft is 4 1
/
2
" forward
of the trailing edge. Mark the position of the
front and rear of the servo onto the wing
using a T-pin.