E-flite Tensor 4D ARF - Manual (Page 24)

24
 8. Install one of the .046" x 6 1 /
4
" rods through
the hole in the center of the side force generator
and into the fuselage spine. Leave at least
1/16" of the rod exposed on the outside of the
side force generator. Glue the rod only to the
fuselage spine.
Note : There is a small notch in the spine for the
location for the carbon rod.
 9. Use a straight edge to make sure the side
force generator is not bent in or out on the
wing. Glue both sides of the rod to the side
force generator.
 10. Repeat Steps 8 and 9 for the remaining
center rod.