E-flite Tensor 4D ARF - Manual (Page 21)

21
Carbon Rod Installation
Required Parts
Assembled airframe
.046" x 11
1 /
4
” carbon rod (4)
.046" x 6 1 /
4
" carbon rod (6)
Required Tools and Adhesives
Foam-safe CA Thin CA
T-Pin
Note : You may want to locate a thin piece
of depron or other foam for the next section.
A thin board will work too. This is necessary
to keep the wing as flat as possible to keep
from inducing any twist in the wing, which will
greatly affect the performance of your Tensor.
 1. Use a T-pin to make small holes where the cross
braces will be installed. These locations are
located 3” back on the top and bottom of the
wing supports at the fuselage, and 2” back for
the side force generators.
Hint : If you look carefully there are notches at
the locations mentioned in Step 1.