E-flite Tensor 4D ARF - Manual (Page 32)

32
Installing the Electronics
Required Parts
Assembled airframe Plywood motor mount
4-40 x 3/8" socket screw (2)
4-40 locknut (2) Hook and loop tape
Required Tools and Adhesives
Foam-safe CA 1/8" drill bit
Drill Receiver
Speed control Motor
 1. Locate the plywood motor mount. Attach your
particular motor at this time using two 4-40 x
3/8” socket screws and two 4-40 locknuts. To
save weight use wood screws, making sure they
are secure in the mount by adding a drop of
thin CA when the protrude from the mount.
 2. Slide the motor into position in the fuselage.
Glue the plywood mount to the fuselage using
foam-safe CA. Trim the fuselage as necessary to
clear the motor and wiring to the motor.