E-flite P-40 Warhawk 300 ARF - Manual (Page 9)

9 E-flite P-40 Warhawk Assembly Manual
Battery Installation
Required Parts
Assembled airframe Motor battery
 1. Slide the motor battery into the fuselage. It
should slide in easily with little force.
 2. When you are ready to fly your aircraft, connect
the lead from the battery to the lead from the speed
control. Tuck the leads into the hole or alongside
the battery so the canopy can be installed.
 3. Place the canopy back on the fuselage.
Make sure that the leads are tucked into the hole in the
fuselage so that the canopy fits correctly on the model.
If not you could loose your canopy during flight.
Spinner Installation
Required Parts
Fuselage assembly Spinner
Required Tools
Nut driver: 5mm Canopy glue
PLEASE NOTE ThAT yOUR SPINNER IS NOT
gLUEd ON FROM ThE FACTORy. IT IS jUST SLId
ON TO ThE PROP ANd NEEdS TO BE REMOvEd
ANd gLUEd ON FOR SAFTEy.
 1. Apply a small amount of canopy glue to the nut.
Use a small amount so the spinner can be easily
removed if the propeller requires replacement.
 2. Slide the spinner back on the propeller. Allow
the glue to fully cure before flying your model.