E-flite P-40 Warhawk 300 ARF - Manual (Page 8)

8 E-flite P-40 Warhawk Assembly Manual
Wing Installation
Required Parts
Fuselage assembly Wing assembly
O-ring tool
Before installing the wing stretch the O-ring slightly
by holding the base of the mount in the wing and
pulling tension on the O-ring. Do not use much
force as you could damage the wing or the mount.
Repeat this process 2 or 3 times. This will allow
the O-ring to stretch some before it is installed.
 1. Remove the canopy from the fuselage by lifting it
upward. The canopy is held on with magnets.
 2. Plug the aileron servo into the receiver.
 3. Position the wing on the bottom of the fuselage.
The pins at the front of the wing will slide into the
holes in the fuselage.
 4. Press the rear of the wing down so the wing fits
tight against the fuselage. Make sure none of the
wires from the inside of the fuselage are exposed
on the top side of the wing.
 5. Use the O-ring tool to pull the O-ring upward
so it can be hooked onto the tab at the rear of the
cockpit as shown.