E-flite P-40 Warhawk 300 ARF - Manual (Page 11)

11 E-flite P-40 Warhawk Assembly Manual
 6. Next, slide the washer back on the motor shaft.
Thread the 5mm locknut back on the shaft.
 7. Use a 5mm nut driver to tighten the nut holding
the propeller on the motor.
 8. Apply a small amount of canopy glue to the nut.
Use a small amount so the spinner can be easily
removed if the propeller requires replacement.
 9. Slide the spinner back on the propeller. Allow
the glue to fully cure before flying your model.
display Stand Assembly
Required Parts
Assembled airframe Display stand base
Display stand strut
 1. Insert the tab from the display stand strut into the
slot in the display stand base. They will fit tight and
not require glue to keep them from coming apart.