E-flite P-40 Warhawk 300 ARF - Manual (Page 4)

4 E-flite P-40 Warhawk Assembly Manual
 2. Use a hobby knife with a #11 blade to cut a
narrow notch at the edge of the servo pocket in the
wing to allow the servo wire from the aileron servo
to fit in.
 3. Press the servo into the servo pocket in the
wing. Make sure to guide the servo wire into the
notch made in the previous step. Note that the
output of the servo faces to the trailing edge (rear)
of the wing.
 4. Place a drop or two of foam-safe CA in the hole
in the servo tab. The CA will go through the hole
and bond the servo to the wing.
 5. Use a hobby knife with a #11 blade to cut a
narrow notch at the edge of the servo pocket in the
fuselage for the elevator servo to allow the servo
wire to fit in.
 6. Press the servo into the servo pocket in the
fuselage. Make sure to guide the servo wire into
the notch made in the previous step. Note that
the output of the servo faces to the front of the
fuselage. Place a drop or two of foam-safe CA in
the hole in the servo tab. The CA will go through
the hole and bond the servo to the fuselage.