E-flite P-40 Warhawk 300 ARF - Manual (Page 3)

3 E-flite P-40 Warhawk Assembly Manual
Recommended Radio Equipment
You will need a minimum 4-channel transmitter,
receiver, and two servos. You can also choose to
purchase a complete radio system. If you are using an
existing transmitter, just purchase the other required
equipment separately. We recommend the crystal-
free, interference-free Spektrum ™ DX5e 2.4GHz DSM ®
5-channel system.
If you own the Spektrum DX5e radio, just add the
AR6100e DSM2 ™ 6-channel receiver and two E-flite
S60 Super Sub-Micro Servos.
Transmitter and Receiver
SPMAR5500 DX5e 5-Channel Transmitter only,
Mode 2
Purchase Separately
SPMAR6100E AR6100E 6-Channel Receiver, Air
And
EFLRS60 S60 Super Sub Micro Servo (2)
Additional Electronics
EFLB4302SJ 430mAh 2S 7.4V 20C LiPo,
20AWG JST
EFLA1010 10-Amp Pro Brushless ESC
Optional Accessories
EFLA110 Power Meter
EFLC3005 Celectra ™ 1–3 Cell
Li-Po Charger
EFLC505 Intelligent 1- to 5-Cell
Balancing Charger
Required Tools and Adhesives
Tools & Equipment
Hobby knife with #11 blade
Phillips screwdriver: #0
Flat blade screwdriver
Nut driver: 5mm
Two-sided tape
Ruler
Adhesives
Foam CA 1oz/Activator 2 oz Pack (EFLA208)
Canopy Glue (PAAPT56)
Note on Lithium Polymer Batteries
Lithium Polymer batteries are significantly
more volatile than alkaline or Ni-Cd/
Ni-MH batteries used in RC applications.
All manufacturer’s instructions and warnings
must be followed closely. Mishandling of
Li-Po batteries can result in fire. Always
follow the manufacturer’s instructions when
disposing of Lithium Polymer batteries.
During the course of building your model we suggest
that you use a soft base for the building surface.
Such things as a foam stand, large piece of bedding
foam or a thick bath towel will work well and help
protect the model from damage during assembly.
Electronics Installation
Required Parts
Fuselage assembly Wing assembly
Servo with horn (2) Receiver
Speed control Flight battery
Transmitter
Required Tools
Foam-safe CA Hobby knife with #11 blade
Two-sided tape Phillips screwdriver: #0
If you are using a computer radio, it is recommended
to start with a new program and clear it before
starting the installation of the electronics. Make sure
the trims, sub-trims and sticks are centered, and no
programmable mixing has been turned on as well.
 1. Use a #0 Phillips screwdriver to remove the
servo horns from the two servos.
The Spektrum trademark is used with permission
of Bachmann Industries, Inc.