E-flite Ascent EP Park Glider ARF - Manual (Page 13)

Step 4. Locate the short servo control arm include with your
servos. Install an easy connector onto the servo control arms as
shown. Clip off the servo arms that are not used.
Step 5. With the elevator and rudder centered and the servos at
their neutral position, slide the easy connectors onto the control
wires and secure the servo arms to the servos. The servo arm
should be 90 degrees to the control wire.
Note: It may be necessary to cut the control wires to allow
the easy connectors to slide on.
Step 6. Tighten the setscrews on the easy connectors, securing
the wires to the servo arms. Final adjustments will be made
when setting up the control throws in Section 6.
14