E-flite Ascent EP Park Glider ARF - Manual (Page 10)

Step 10. Remove the fin from the boom. Using a sharp hobby
knife, remove the covering from the fin tab just inside the lines
drawn in the previous step.
Step 11. Carefully sand the tail boom inside the lines drawn in
Step 9 to remove the paint. Use masking tape to protect the
boom from the sandpaper.
Step 12. Using 30-minute epoxy, glue the vertical fin in place.
Make sure to get adequate epoxy inside the bottom portion of the
boom where the fin’s tab makes contact. Use masking tape to
hold the fin in place while the epoxy cures. Make sure the fin is
positioned 90 degrees to the horizontal stabilizer.
Step 13. Once the epoxy has cured, locate the boom skid and mark
its position on the bottom of the boom. The skid should be placed
in line with the vertical fin 90 degrees to the horizontal stabilizer.
Step 14. Trim the covering just inside the lines drawn in the
previous step and glue the skid in place using 6-minute epoxy.
11
A
A
B
B