E-flite Ultimate Fx 3D ARF - Manual (Page 33)

33
Note: When using the E-Flite outrunner motor
and mount, you will need to shorten the motor
mount stick by 13/16" (20mm).
Attach the outrunner motor using the outrunner
stick mount (EFLM1915). Attach mount with
motor to the motor mount stick.
 4. Secure the speed control location using hook and
loop. Run the lead from the speed control to the
receiver. It may be necessary to use a servo extension.
Exact speed control location may vary depending on
the brand used and the center of gravity. This photo
shows the location in the front of the fuse if you are
using our E-flite™ 20-amp Brushless ESC.