E-flite Ultimate Fx 3D ARF - Manual (Page 19)

19
 3. Install the wheel pants and wheels. Use needle-nose
pliers to insert the wheel retainers on the ends of each
of the axle portions of the landing gear inside of the
wheel pant. Each wheel pant is secured using two
2mm x 6mm sheet metal screws and a wheel pant
strap. Drill the holes for the screws into the wheel
pants using a hobby knife.
Note: If you choose not to use the wheel pants,
you can secure the wheels on the landing gear
using the wheel retainers. Use hot glue or foam
compatible CA to glue the retainers onto the
end landing gear. Use care not to glue the
wheel to the landing gear.