Watts FH - Manual (Page 2)

Instructions for Installation and Service
I nstallers Please Note:
A. Hose end must be installed sufficiently lower than seat end to allow for proper
drainage.
B. Inner valve assembly must be removed from sill cock before heating seat end
for solder connection to avoid burning the rubber seat washer.
The frost-proof sill cock assures no-freeze operation because the valve mechanism shuts
off water inside the building where it is heated. If building will be unheated for any length
of time, then all water lines should be drained and plumbing fixtures winterized.
A plastic siding wedge is provided to compensate for lap siding
installations. Slip the wedge between frost-pr oof flange and siding
to form an attractive finish and solid base for mounting.
Secure sill cock flange with two #8 or #10 oval head wood scr ews
(of proper length) or with appr opriate masonry hardwar e.
IS-FH-M1
Series FH-1-M1
Frost-Pr oof Sill Cock Freezeless Wall Hydrant Self-Draining
Sizes: Inlet
1
⁄
2
" solder or
1
⁄
2
" male IPS
Provides a year round
supply of outside water
without fear of pipes
freezing and bursting.
Siding Wedge
Ordering COde nO. Kit nO. ValVe SerieS Size
0723126 FH-M1-RK FH-M1 All
Kit consists of: Check sub-assembly, Check spring and Stem packing.
Series FH-1-M1
To Service:
Remove handle and bonnet, slide stem out. Replace all rubber parts
and disc screw. Reinsert stem, bonnet and handle.
IS-FH-M1 1240 EDP# 1910519 © 2012 Watts
USA: Tel: (978) 688-1811 • Fax: (978) 794-1848 • www.watts.com
Canada: Tel: (905) 332-4090 • Fax: (905) 332-7068 • www.watts.ca
limited Warranty: Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of
original shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
tHe WarrantY Set FOrtH Herein iS giVen eXPreSSlY and iS tHe OnlY WarrantY giVen BY tHe COMPanY WitH reSPeCt tO tHe PrOdUCt. tHe COMPanY MaKeS nO OtHer
WarrantieS, eXPreSS Or iMPlied. tHe COMPanY HereBY SPeCiFiCallY diSClaiMS all OtHer WarrantieS, eXPreSS Or iMPlied, inClUding BUt nOt liMited tO tHe iMPlied
WarrantieS OF MerCHantaBilitY and FitneSS FOr a PartiCUlar PUrPOSe.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no
control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to
determine your rights. SO Far aS iS COnSiStent WitH aPPliCaBle State laW, anY iMPlied WarrantieS tHat MaY nOt Be diSClaiMed, inClUding tHe iMPlied WarrantieS OF
MerCHantaBilitY and FitneSS FOr a PartiCUlar PUrPOSe, are liMited in dUratiOn tO One Year FrOM tHe date OF Original SHiPMent.
A Watts Water Technologies Company