Watts LFMMV - Manual (Page 2)

Hot
140°F
Cold Cold
LFMMV-M1
Mixed
110°F
Mixed
110°F
Hot Cold
Cold
Supply
Stops
Typical
Two Handled Faucet
Typical
Two Handled Faucet
Figure 2 – Typical ASSE 1070 Application
Quick-Connect Installation
1. Mark pipe as shown.
This is pipe insertion depth.
2. Clean pipe end.
1. Remove collet clip.
2. Depress collet.
3. Pull tubing from tailpiece.
3. If using PEX tubing, insert pipe
stiffener (provided) into end of pipe.
4. Push tubing into tailpiece up to mark.
5. Insert collet clip.
To Connect
To Disconnect
PEX tubing only
Pipe Stiffener
Tail Piece
Mark
Collet clip
Collet depressed
1 1 /
2
in. (38.1mm)
1 3 /
4
in. (44.45mm)
1 7 / 8 in.(47.63mm)
1 / 2 in. Pipe (12.7mm)
3 /
4
in. Pipe (19.05mm)
1in. Pipe (25.4mm)
Figure 1 – Typical ASSE 1069 Application
Typical LFMMV-M1 Applications
Cold Hot
LFMMV-M1
Mixed
1. Remove collet clip.