Watts DWB User Manual
Page 3
Figure 6
Figure 7
Figure 8
Stop Valve Position
(if required)
Trim Wall Box
To Accomodate
Stop Valve
4. Level the wall box and fasten it to the wall stud-
ding, Fig. 6.
5. Install drain tubing and trap as required by local
codes.
6. Solder a piece of
1
⁄
2
" copper tubing to the
sweat ells provided, Fig. 7.
A. Warning: do not sweat pipe in Duo-Clozure
wall box. Extreme heat from a torch
will deform or melt the wall box.
B.
Clean pipe and ells with steel wool prior to
soldering.
C.
If service stops are required by code, see Fig. 8.
7. Secure ells to Duo-Clozure wall box with screws pro-
vided. Complete installation of hot and cold water
lines to the system.
3
IS-2M2 DWB.indd 3
9/24/08 9:09:37 AM
See also other documents in the category Watts Accessories for electrical:
- LF3110 (1 page)
- KA2-A (2 pages)
- 710 203 (1 page)
- 718 203 (1 page)
- 522 222 (1 page)
- SSC (1 page)
- 670 303B (1 page)
- LF4001E (1 page)
- Divertaflo M9400 Series (2 pages)
- 77145 Series (12 pages)
- 637 171B (1 page)
- 120 9TSS (1 page)
- 667 303B (1 page)
- DWB (2 pages)
- 400 223 (1 page)
- 682 003 (2 pages)
- 15M2 (2 pages)
- LF15M2 (2 pages)
- 15M2 (2 pages)
- LFSS (2 pages)
- LF3002 (1 page)
- FH (1 page)
- FH (2 pages)
- LF1212BSS (1 page)
- 121 2BSS (1 page)
- 650 003 (2 pages)
- SC8 (2 pages)
- LF3100 (1 page)
- HY42 (2 pages)
- 630 203 (1 page)
- TWS (2 pages)
- 559 172B (1 page)
- 508 173 (1 page)
- BIC-1000 (8 pages)
- 500800 (2 pages)
- 500800 (8 pages)
- 680 003 (1 page)
- LF150A (2 pages)
- FS-4560DWSS (1 page)
- SC (1 page)
- LF3008 (1 page)
- LF3001A (1 page)
- 201 173 (1 page)
- 605 103 (1 page)