Watts Jumbo Plastic Housing - Manual (Page 3)

3
Routine Cartridge Replacement
1 . Close inlet valve .
2 . Close outlet valve .
3 . Open valve on drain, if a drainpipe has been installed .
4 . Press pressure relief button to relieve pressure .
5 . Remove lid after pressure has been relieved .
6 . Rotate cartridge counterclockwise and pull upward . Remove the
cartridge .
7 . Install new cartridge . Push downward and rotate clockwise to
engage locking tabs lubricating O-rings if necessary .
8 . Check lid O-ring to ensure it is properly seated . Lubricate if
necessary .
9 . Replace lid .
10 . Replace eyebolts and tighten . (Hand tight is sufficient .)
11 . Close valve on drain if a drainpipe was installed .
12 . Open outlet pipe completely .
13 . Open inlet pipe slowly to check for leaks .
14 . Vent filter to dispel air by depressing pressure relief button . Be
careful when relieving pressure or dispelling air if high tempera-
ture water is being filtered .
Note: If leaks occur, close the inlet and outlet pipes and follow pro-
cedures previously described under “Caution” section above .
Item # DescrIptIon
1 ¼" Pressure Gauge
2, 6 & 7 Pressure relief assembly includes cap, spring and stem
2 Pressure release button
3 Wing Nut
4 Washer for lid closure
5 Lid with brass reinforced gauge port
5A Lid without brass reinforced gauge port
6 Pressure relief spring
7 Lock pin with O-ring
8 O-ring for lid closure, EPDM
9 Stud for eye bolt
10 Eyebolt
11 Adapter 2" PVC
12 Drain plug ½" NPS without O-ring
13 Drain plug O-ring
14 Coupler
15 Coupler O-ring
16 Plug for second outlet
17 Nut for plumbing adapter
18 Base
19 Mounting Bolts
Parts List
Note: Two outlets are provided so outlet piping may be direct-
ed to either direction. A plug is provided to close off the outlet
not being used.
moDeL number meDIA type mIcron rAtInG per cAse
PWWJCP1AB 1 1 Absolute 1
PWWJCP1 1 1 1
PWWJCP5 1 5 1
PWWJCP20 1 20 1
PWWJCP50 1 50 1
PWWJCM150 1 150 1
moDeL number meDIA type mIcron rAtInG per cAse
PWWJCMB1 1 1 1
PWWJCMB5 1 5 1
PWWJCMB20 1 20 1
PWWJCMB50 1 50 1
moDeL number mAX. FLoW cApAcIty cHLorIne
reDuctIon
PWWJCAC5 15 GPM 140,000 Gals. 90%
Note: We build filtration systems, or they may be installed on site.
For more information please inquire.
Pleated Cartridges
Ideal for more critical applications, offering greater efficiency,
more surface area for greater throughput and reduced cost .
Depth Cartridges
Melt blown Polypropylene cartridges are recommended when
depth filtration is necessary for the reduction of soft particulate .
Activated Carbon Cartridge
Ideal for whole house filtration to reduce chlorine, taste, odors
and sediment .
note: 5, 20, 50 and 150 micron cartridges are cleanable and reusable to reduce
costs.