Brother HL-1800 series User Manual
Page 199
APPENDIX
A–29
LAN Connection
Caution
Connect this product to a LAN connection that is not subjected to over
voltages.
Geräuschemission / Acoustic Noise Emission (For Germany Only)
Lpa < 70 dB (A) DIN 45635-19-01-KL2
IT power system (For Norway Only)
This product is also designed for IT power system with phase to phase
voltage 230 V.
IMPORTANT - Wiring Information (For U.K. Only)
If the power cord supplied with this printer is not suitable for your electrical
outlet, remove the plug from the mains cord and fit an appropriate three-pin
plug. If the replacement plug is intended to take a fuse then fit a fuse with
the same rating as the original.
If a moulded plug is severed from the power cord then it should be destroyed
because a plug with cut wires is dangerous if plugged into a live socket
outlet. Do not leave it where a child might find it.
In the event of replacing the plug fuse, fit a fuse approved by ASTA to
BS1362 with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE PROPERLY EARTHED.
The wires in the mains cord are coloured in accordance with the following
code:
Green
and
yellow:
Ground
Blue:
Neutral
Brown:
Live