Banner WORLD-BEAM QS30 High-Power Opposed Mode - Manual (Page 3)

Specifications
Supply Voltage and Current
Emitter: 10 to 30V dc (10% maximum ripple) at
less than 70 mA
Receiver: 10 to 30V dc (10% maximum ripple) at
less than 22 mA (exclusive of load)
Beam
875 nm, infrared
Sensing Range
Excess gain of 2 at 213 m (700')
Output Configuration
Bipolar current sinking (NPN) white wire; current
sourcing (PNP) black wire
Output Rating:
100 mA max
OFF-state leakage current: less than 200 µA
ON-state saturation voltage: less than 1.5V @
100 mA, less than 900 millivolts at 10 mA
Protected against false power-up and continuous
overload or short circuit of outputs
Output Response
30 milliseconds ON and 30 milliseconds OFF; 5
ms repeatability
Adjustments
Light Operate/Dark Operate — dependent on
model selected
Frequency via gray wire
A: Gray (+)
B: Gray (-)
Emitter only: LED inhibit via white wire White (-)
turns emitter LED OFF (to allow verification of sen-
sor operation)
Indicators
Green LED: Power ON
Frequency indicator (A or B)
Receiver only:
Yellow LED: Output conducting
4-LED Signal Strength light bar
Environmental Rating
Cabled models: IP67, NEMA 6P
QD models: IP69K per DIN 40050-9
Construction
ABS plastic housing; impact-resistant lens material
Connection
5-wire cable (2 m or 9 m) or 5-pin integral Euro-style quick-
disconnect fitting
Operating Conditions
Temperature: -20° to +60° C (-4° to +140° F)
Relative Humidity: 90%; non-condensing
Mounting Torque
Maximum 4.5 Nm (40 in lbs) with included 30 mm mounting
nut
Certifications
Application Notes
1. When multiple sensors are used in close proximity
(see Figure 1 for separation distance), position sen-
sors such that the alternate frequency emitter is not
within the receiver's field of view. Contact the Banner
Application team for additional information.
2. Prolonged outdoor use in direct sunlight may cloud
the lens. Contact Banner for other outdoor solutions.
Dimensions
33.0 mm
(1.30")
12.5 mm
(0.49")
3.5 mm
(0.14")
44.0 mm
(1.73")
1.3 mm
(0.05") 22.0 mm
(0.87")
2 x ø3.3 mm (0.125")
max. torque
0.7 Nm (6 in lbs)
M30 x 1.5 Thread
max. torque
6 Nm (53 in lbs)
with included 30 mm
mounting nut 13.0 mm
(0.51")
5.0 mm
(0.20")
32.5 mm
(1.28")
43.0 mm
(1.69")
34.0 mm
(1.34")
21 mm
(0.83")
9.0 mm
(0.35")
Bracket dimensions are shown on page 5.
QD Models
Cabled Models
WORLD-BEAM® QS30 Series Sensors
P/N 115011 Rev. E www.bannerengineering.com - tel: 763-544-3164 3