Banner SL30 Series Slot Sensors - Manual

SL Series Slot Sensor
SL0 Series Slot Sensor
Self-contained opposed-mode sensor pair
Printed in USA P/N 60073
SL0 Series Slot Sensor Features
• An easy-to-use self-contained opposed-mode sensor pair in a rugged U-shaped housing
• Easy and economical to mount
• Molded-in beam guides simplify mounting and beam placement
• 30 mm slot width for a wide variety of sensing applications
• Applications include hole detection, gear tooth detection, edge guiding and counting
of opaque materials
• 10 to 30V dc operation
• Bipolar PNP/NPN outputs
• Choose 1 millisecond or 300 microsecond response
• 2 mm effective beam
• Dark or light operate
• Choose integral, unterminated cable or QD models
Models
Slot
Width Cable*
Supply
Voltage
Output
Type Response Repeatability
SL030VB6
SL0 Series Slot Sensor Models
Infrared, 890 nm
1 millisecond 250 microseconds
30 mm
(1.2")
2 m (6.5')
5-wire cable
10-30V dc
Bipolar
NPN (sinking)
and
PNP (sourcing)
5-Pin
Euro-style QD
SL030VB6Q
2 m (6.5')
5-wire cable
5-Pin
Euro-style QD
SL030VB6YQ
SL030VB6Y
300 microseconds 75 microseconds
*NOTES: 1) 9 m (30') cables are available by adding suffix “W/30” to the model number of the cabled version (e.g., SL030VB6 W/30).
2) A model with a QD connector requires an accessory mating cable. See page 4.
WARNING . . .
Not To Be Used for Personnel Protection
Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.
These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications.
A sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner Safety
Products catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.
!