Banner D11 Series - Manual (Page 4)

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 Telephone: (612) 544-3164 FAX (applications) (612) 544-3573
D11 Series
Dimensions
Sensitivity
Adjustment
Power Indicator
Output Indicator
Plastic Fiber
Emitter Port
Plastic Fiber
Receiver Port Mounting
Bracket
(Included)
35.0 mm
(1.38 in)
17.6 mm
(0.69 in)
64.1 mm
(2.53 in)
11.0 mm
(0.43 in)
29.0 mm
(1.14 in)
Slide Up
to Release
Fibers
Sensitivity
Adjustment
Power Indicator
Output Indicator
Plastic Fiber
Emitter Port
Plastic Fiber
Receiver Port Mounting
Bracket
(Included)
35.0 mm
(1.38 in)
17.6 mm
(0.69 in)
64.1 mm
(2.53 in)
77.7 mm
(3.06 in)
11.0 mm
(0.43 in)
29.0 mm
(1.14 in)
Slide Up
to Release
Fibers
,
,
37.1 mm
(1.46 in)
26.2 mm
(1.03 in)
31.2 mm
(1.23 in)
5.8 mm
(0.23 in)
10.9 mm
(0.43 in)
A
Section A-A
A
2 x C 'sink
ø 7.9 mm (0.31 in)
3.2 mm (0.13 in) deep
ø4.4 (0.18 in) thru
2 x ø 3.25 mm
(0.128 in)
2 x 3.5 mm
(0.14 in)
5.5 mm
(0.22 in)
11.0 mm
(0.44 in)
2.5 mm
(0.10 in)
2 x 0.9 mm
(0.04 in)
8.6 mm
(0.34 in)
Cabled models
Quick disconnect model s
Mounting Bracket
Fiber Adaptor
Plastic Fiber Installation:
1. Cut fiber ends per instructions
included with the fibers. Slide the
fiber gripper up (open). For 0.25 mm
or 0.5 mm diameter fibers, insert the
adapter (shown below) into the ports
as far as it will go.
2. All fibers: Insert the prepared plastic
fiber sensor ends gently into the
ports as far as they will go.
3. Slide the fiber gripper back down to
lock.
WARRANTY:
Banner Engineering
Corporation warrants it products to be
free from defects for one year. Banner
Engineering Corporation will repair or
replace, free of charge, any product of
its manufacture found to be defective
at the time it is returned to the factory
during the warranty period. This
warranty does not cover damage or
liability for the improper application of
Banner products. This warranty is in
lieu of any other warranty either
expressed or implied.
Adaptor (included) is for use with 0.25
mm (0.01") or 0.5 mm (0.02")
diameter fibers