Banner SPS101 DC Sensor Power Supply User Manual
Sps101 dc sensor power supply, Sps101 features, Warning

SPS101 DC Sensor Power Supply
For Powering Banner dc Sensors
Printed in USA
04/02
P/N 66959 rev. B
SPS101 Features
•
Converts 120V ac line voltage to low voltage dc for powering any Banner dc
sensor
†
which has either 4- or 5-pin Euro-style quick-disconnect (QD)
•
SPS101 models: 5 amp-rated SPST relay for switching ac loads or large dc loads
•
SPS101S models: optically-isolated SPST solid-state output for switching ac or dc
loads
•
Models with “Q” suffix require a sensor with a pigtail QD connector; models with
“QP” suffix connect to a sensor with either an integral or pigtail quick-disconnect
•
Isolated dc output
†
Note: SPS power supplies are not for use with NAMUR sensors or personal safety products.
SPS101QP
SPS101Q
105-130V ac
60 Hz
5-pin Euro-style QD*
5-pin Pigtail Euro-style QD
5-pin Mini QD
Model
Supply Voltage
Sensor Connection
Supply/Output Cable
SPS101SQP
SPS101SQ
5-pin Euro-style QD*
5-pin Pigtail Euro-style QD
“Form A” (SPST) electromechanical relay
(see specifications for rating information)
Output Type
SPST Optically-isolated solid-state switch
(see specifications for rating information)
*Requires 4- or 5-pin Pigtail Euro QD on sensor.
SPS101 Sensor Power Supply Models
SPS101 Sensor Power Supply Dimensions
Model Suffix “QP”
Model Suffix “Q”
Mini-Style Connector
“QD” Receptacle Pin Numbering
(Male Pins)
5-pin female Euro-style
QD connector
500 mm (19.7")
pigtail cable
142.5 mm
(5.61")
50.0 mm
(1.97")
ø 38.1 mm (1.50")
Power Indicator
M5 (#10)
Screw Clearance (2)
5-pin Mini-Style QD Connector
Threaded Base M30 x 1.5
40.1 mm
(1.58")
48.8 mm
(1.92")
45.0 mm
(1.77")
64.5 mm
(2.54")
4.8 mm
(0.19")
5-pin female Euro-style
QD connector
89.9 mm
(3.54")
14 mm
(0.6")
107.4 mm
(4.23")
132.5 mm
(5.20")
Output Indicator
WARNING . . .
Not To Be Used for Personnel Protection
Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.
These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications. A sensor failure
or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner Safety Products catalog for
safety products which meet OSHA, ANSI and IEC standards for personnel protection.
!
For sensors with
Euro-style
pigtail or
integral
QD
connector
For
sensors
with Euro-
style QD pigtail
only
1
2
3
4
5
Euro-Style Connector
“QD” Receptacle Pin Numbering
(Female Pins)
1
2
3
4
5