Banner Q10 Series - Manual (Page 4)

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 Telephone: (612) 544-3164 FAX (applications) (612) 544-3573
Q10 Series
WARRANTY: Banner Engineering Corporation warrants it products to be free from defects for one year. Banner Engineering
Corporation will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned
to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of
Banner products. This warranty is in lieu of any other warranty either expressed or implied.
WARNING These photoelectric presence sensors do NOT include the self-checking redundant circuitry
necessary to allow their use in personnel safety applications. A sensor failure or malfunction can result in either
an energized or a de-energized sensor output condition.
Never use these products as sensing devices for personnel protection. Their use as a safety device may create
an unsafe condition which could lead to serious injury or death.
Only MINI-SCREEN ™ , MULTI-SCREEN ™ , MACHINE-GUARD and PERIMETER-GUARD Systems, and other systems so
designated, are designed to meet OSHA and ANSI machine safety standards for point-of-operation guarding devices. No other
Banner sensors or controls are designed to meet these standards, and they must NOT be used as sensing devices for
personnel protection.
!
Mounting Specifications
Flat Mounting Stand-off Mounting
M2.5 x 0.45
Machine Screw
12mm Long
Nylon Spacer
M2.5 x 0.45 Machine Screw
25 mm (1.0 in) long
Split Lockwasher
Hex Nut
All hardware shown is supplied with each sensor.