Banner Q10 Series - Manual (Page 2)

Q10 Series
page 2 Banner Engineering Corporation
Quick Disconnect (QD) Cables
28 mm max.
(1.1 in)
ø10 mm max.
(0.4 in)
The following is the selection of cables available for the Q10 QD models
DImensions Style Model Length For use with
3-pin
Pico Style
straight
PKG3-2 2 m (6.5 ft)
All Q10 sensors with
quick-disconnect fitting
Black Wire
Blue Wire Brown Wire
Pinout
20 mm
(0.8 in)
25 mm max.
(1.0 in)
ø12 mm max.
(0.5 in)
3-pin
Pico Style
right-angle
PKW3-2 2 m (6.5 ft)
Product Specifications
Sensing Beam
Adjustments Diffuse models (only); single-turn, top-mounted SENSITIVITY control for adjustment of system gain (turn
clockwise to increase)
Supply Protection Circuitry Protected against reverse polarity
Output Configuration SPST solid-state dc switch;
Choose NPN (current sinking) or PNP (current sourcing) models
Choose light operate (N.O.) or dark operate (N.C.) models
Output Rating 150 mA maximum
Off-state leakage current: <10 microamps at 30V dc;
On-state saturation voltage: <0.5V at 10 mA dc; <1.5V at 150 mA dc
Output Protection Circuitry Protected against false pulse on power-up and continuous overload or short-circuit of outputs
Overload trip point
≥
220mA, typical, at 20ºC
Output Response Time Opposed mode: 8 ms "on", 4 ms "off"; Diffuse mode: 3 ms "on" and "off"
Indicators Opposed mode receivers and diffuse mode sensors have two LEDs: Green and Yellow
GREEN glowing steadily = power to sensor is "on"
GREEN flashing = output is overloaded
YELLOW glowing steadily = light is sensed
YELLOW flashing
= marginal excess gain (1-1.5x) in light condition
Emitters have one Green LED to indicate when power to sensor is "on"
Repeatability Opposed mode: 1.0 ms; Diffuse mode: 0.75 ms
Construction Housings are black ABS; Rated UL 94V0
Lenses are hermetically-sealed glass; lens covers are clear acrylic
Circuitry is epoxy-encapsulated and completely sealed
Stainless steel M2.5 mounting hardware is included
Environmental Rating IP
54 (NEMA 5)
Connections 2 m (6-1/2 ft) attached cable, or 3-pin pico-style quick-disconnect fitting;
Cables for QD models are purchased separately
Operating Temperature -40º to +70ºC (-40º to 158ºF); Maximum relative humidity 90% at 50ºC (non-condensing)
Infrared, 880 nm
Supply Voltage and Current 10 to 30V dc (10% maximum ripple); Emitter or receiver: 15 mA; Diffuse models: 20 mA
(exclusive of load)