Banner S18 Series - Manual (Page 3)

S186ELD Laser Diode Emitter
P/N 35749 rev. D
3
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Supply Voltage and Current 10 to 30V dc (10% maximum ripple) at less than 35 mA
Supply Protection Circuitry Protected against reverse polarity
Sensing Beam 650 nm visible red Class 1 laser (temperature coefficient 0.2 nm/°C)
Pulse Width: 7µs
Rep Rate: 30µs
Peak Output Power: less than 1 milliwatt
Beam Diameter at Aperture 2.5 mm (0.10") collimated ellipse
Beam Divergence ±0.5 milliradians typical
Laser Control Enable beam by applying 0V dc or by opening circuit; apply +10 to 30V dc to black wire to inhibit beam
Indicators Green indicator, visible through rear cover, indicates power applied
Construction M18 x 1 threaded yellow PBT polyester barrel housing. Acrylic lens. Electronics totally encapsulated.
Two mounting nuts are included.
Environmental Rating NEMA 6P; IEC IP67
Connections PVC-jacketed 2 m (6.5') or 9 m (30') attached cable, or 4-pin Euro-style quick-disconnect (QD) fitting.
Operating Conditions Temperature: -10° to +50° C (+14° to 122° F)
Maximum relative humidity: 90% at 50° C (non-condensing)
Laser Classification Class 1 laser product complies with 21 CFR 1040.10, EN60825-1:2001, except for deviations pursuant to
Laser Notice 50, dated 7-26-01.
Certifications
LISTED
Specifications
Dimensions
Hookups
Cabled Model QD Model
M18 x 1
1.27 mm
(0.05")
(2) Jam Nuts
24.1 mm (0.95") O.D.
(Supplied)
Green LED
Power ON Indicator
4.0 mm
(0.16")
41.4 mm
(1.63")
59.9 mm
(2.36")
65.5 mm
(2.58")
85.0 mm
(3.35")
Cabled Model QD Model
4
10-30V dc
Beam
Attenuator
–
+ 1
3
Key
1 = Brown
2 = White
3 = Blue
4 = Black
4
10-30V dc
Beam
Attenuator
–
+ 1
3
2