Banner R-GAGE QT50R-RH Retroreflective High Sensitivity - Manual (Page 4)

Response Speed
* Default settings
Switch 8 ON OFF ON/OFF
0 32 ms 68 ms 100 ms
1* 258 ms 998 ms 1256 ms
Specifications
Range
The sensor is able to detect a proper object (see De-
tectable Objects) from 1 to 15 m (3.3 to 49.2 ft), de-
pending on target
Detectable Objects
Objects containing metal, water, or similar high-dielec-
tric materials
Operating Principle
Frequency modulated continuous-wave (FMCW) radar
Operating Frequency
24.00 to 24.25 GHz, ISM Band (varies slightly with
model, depending on national telecom regulations)
Supply Voltage
12 to 30V dc, less than 100 mA, exclusive of load
Supply Protection Circuitry
Protected against reverse polarity and transient over-
voltages
Delay at Power-up
Less than 2 seconds
Output Configuration
Bipolar NPN/PNP output, 150mA; DIP switch 7 selects
N.O. (default) or N.C. operation
Output Protection
Protected against short circuit conditions
Response Time
DIP-Switch 8 selects ON/OFF response time
Indicators
Power LED: Green (power ON)
Signal Strength LED: Red, flashes in proportion to
signal strength. Steady on at 4x excess gain. Only indi-
cates signal amplitude, not target distance.
Output LEDs: Yellow (output energized) / Red (config-
uration)
See
Figure 2. R-Gage Features on page 2
Adjustments
DIP-switch-configurable sensing distance, sensitivity,
response time, and output configuration
Construction
Housing: ABS/polycarbonate
Lightpipes: Acrylic
Access Cap: Polyester
Operating Temperature
−40° to +65° C (−40° to +149° F)
Environmental Rating
IP67
Connections
Integral 5-wire 2 m (6.5 ft) cable or M12 Euro-style QD
fitting. QD models require a mating cordset
Certifications
ETSI/EN 300 440; FCC part 15; RSS-210; ANATEL
Category II; CMII Category G; ARIB STD T-73; for oth-
ers, contact Banner Engineering.
FCC ID: UE3QT50RUS—This device compiles with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Este equipamento opera em caráter secundário, isto é, não tem direito à proteção
contra interferência prejudicial, mesmo de estações do mesmo tipo e não pode cau-
sar interferência a sistemas operando em caráter primário.
R-GAGE™ QT50RAF Sensor
4 www.bannerengineering.com - tel: 763-544-3164 P/N 135460_web
Rev. E