Banner ECONO-BEAM SE61 Series - Manual (Page 2)

ECONO-BEAM ® –
Diffuse AC Sensors
Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: 888.373.6767 • http://www.baneng.com • Email: [email protected]
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or
replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period.
This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty
either expressed or implied.
ECONO-BEAM AC Diffuse Specifications
Certifications
Supply Voltage and Current 120V ac (±20%, 50-60 Hz)
Supply Protection Circuitry Protected against transient voltages
Output Configuration Solid-state (FET).
SE61AW1 models: normally open (light operate)
SE61RW1 models: normally closed (dark operate)
Output Rating Maximum steady-state load capability 300 mA to 50°C ambient (122°F)
Inrush capability: 1 amp for 20 milliseconds (non repetitive)
Off-state leakage current: less than 50 µA rms
On-state voltage drop:
≤
3 volts at 300 mA load,
≤
2 volts at 15 mA load
Output Protection Circuitry Protected against false pulse on power-up
Output Response Time 10 milliseconds ON and 10 milliseconds OFF
Response time specification of load should be considered when important.
(NOTE: 20 millisecond delay on power-up.)
Repeatability 2.3 milliseconds; independent of signal strength
Indicators Red indicator LED on top of unit is ON whenever the sensor sees its modulated light source
Construction Reinforced thermoplastic polyester housing, totally encapsulated and acrylic lenses
Environmental Rating Meets NEMA standards 1, 2, 3, 3S, 4, 4X, 12, and 13; IEC IP66
Connections PVC-jacketed 3-wire 2 m (6.5') or 9 m (30') cables
Operating Conditions Temperature: 0° to 50°C (32° to 122°F)
Maximum relative humidity: 90% at 50°C (non-condensing)
ECONO-BEAM AC Diffuse Hookup
bn
bk
bu
120V ac ( ± 20%)
Load
Sensing Beam Infrared, 880 nm
6.1 mm
(0.24")
LED Indicator
(Receiver Only)
140.4 mm
(0.56")
ECONO-BEAM AC Diffuse Dimensions