Banner Q45 Series - Manual (Page 6)

0 Diagnostic Event Counter: This event is sent when ever a flag in attribute 9 is set. This event also sends one data
byte. This byte contains the value of attribute #8, the Diagnostic Error Counter. Typically, this event is sent as a result of
a low gain condition.
Write ON/OFF: These events are sent when the Cyclic Timer has expired. Either a WRITE ON or a WRITE OFF
special event is sent reflecting the state of the input. This event can be masked by clearing attribute 6.
Change Of State ON: When the output of the sensor transitions to the ON state this message is sent. This event can be
masked by clearing attribute 6.
Change Of State OFF: When the output of the sensor transitions to the OFF state this message is sent. This event can be
masked by clearing attribute 6.
Banner Engineering Corp. 9714 10th Ave. No., Minneapolis, MN 55441 Telephone: (612) 544-3164 FAX (applications): (612) 544-3573
WARRANTY: Banner Engineering Corporation warrants its products to be free from defects for one year. Banner Engineering Corporation will repair or
replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty
does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied.
EVENTS
Event Description Output Data Parameters Output Data Parameter Type
0 Diagnostic Event Counter Counter Value Unsigned 8
Write ON None
Write OFF None
Change of State ON None
Change of State OFF None