Metrohm 850 Professional IC Anion MSM-HC MCS Prep 2 - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
850 Professional IC –Anion – MSM-HC – MCS – Prep 2
￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 3
1.3 About the documentation ................................................... 4
1.3.1 Symbols and conventions ........................................................ 4
1.4 Safety instructions ................................................................ 5
1.4.1 General notes on safety ........................................................... 5
1.4.2 Electrical safety ........................................................................ 5
1.4.3 Tubing and capillary connections ............................................. 6
1.4.4 Flammable solvents and chemicals ........................................... 6
1.4.5 Recycling and disposal ............................................................. 6
2 Overview of the instrument 8
2.1 Front ...................................................................................... 8
2.2 Rear ...................................................................................... 10
3 Installation 13
3.1 About this chapter .............................................................. 13
3.2 Initial installation ................................................................ 13
3.3 Installation diagram ........................................................... 16
3.4 Setting up the instrument .................................................. 22
3.4.1 Packaging .............................................................................. 22
3.4.2 Checks .................................................................................. 22
3.4.3 Location ................................................................................ 22
3.5 Capillary connections in the IC system ............................. 23
3.6 Rear of the instrument ....................................................... 25
3.6.1 Rollers and handle ................................................................. 25
3.6.2 Positioning and connecting the detector ................................ 28
3.6.3 Transport locking screws ....................................................... 30
3.6.4 Leak sensor ........................................................................... 30
3.6.5 Drainage tubing ..................................................................... 31
3.7 Capillary and cable feed-throughs .................................... 33
3.8 Eluent ................................................................................... 36
3.8.1 Connecting eluent bottle ....................................................... 36
3.9 Eluent degasser ................................................................. 40
3.10 High pressure pump ........................................................... 41
3.10.1
Capillary connections high pressure pump/purge valve ........... 41
3.10.2 Deaerating the high pressure pump ....................................... 44