Metrohm 850 Professional IC AnCat Nonsuppressed - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
850 Professional IC–AnCat – non-suppressed
￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 1
1.3 About the documentation ................................................... 2
1.3.1 Symbols and conventions ........................................................ 2
1.4 Safety instructions ................................................................ 3
1.4.1 General notes on safety ........................................................... 3
1.4.2 Electrical safety ........................................................................ 3
1.4.3 Tubing and capillary connections ............................................. 4
1.4.4 Flammable solvents and chemicals ........................................... 4
1.4.5 Recycling and disposal ............................................................. 4
2 Overview of the instrument 6
2.1 Front ...................................................................................... 6
2.2 Rear ........................................................................................ 8
3 Installation 11
3.1 About this chapter .............................................................. 11
3.2 Initial installation ................................................................ 11
3.3 Installation diagram .......................................................... 14
3.4 Setting up the instrument .................................................. 16
3.4.1 Packaging .............................................................................. 16
3.4.2 Checks .................................................................................. 16
3.4.3 Location ................................................................................ 16
3.5 Capillary connections in the IC system ............................. 17
3.6 Rear of the instrument ....................................................... 19
3.6.1 Rollers and handle ................................................................. 19
3.6.2 Positioning and connecting the detector ................................ 22
3.6.3 Transport locking screws ....................................................... 24
3.6.4 Leak sensor ........................................................................... 24
3.6.5 Drainage tubing ..................................................................... 25
3.7 Capillary and cable feed-throughs .................................... 27
3.8 Eluent ................................................................................... 30
3.8.1 Connecting eluent bottle ....................................................... 30
3.9 Eluent degasser ................................................................. 34
3.10 High pressure pump ........................................................... 35
3.10.1
Capillary connections high pressure pump/purge valve ........... 35
3.10.2 Deaerating the high pressure pump ....................................... 38