Metrohm 748 DH Sample Changer - Manual (Page 11)

2.4 Sample racks
748 DH Sample Changer
9
2.4 Sample racks
Place sample racks in position.
Place 6.1432.320 sample beaker in the soak position (see
page 4).
Use 6.2060.000 holders to carry the racks.
2.5 Sample Changer start up
Connect the RS232 interface of the Sample Changer with a
COM of the computer:
Cables:
25-pole / 9-pole, 3 m............................................. 6.2125.110
25-pole / 25-pole, 3 m........................................... 6.2125.060
Extension cable 25-pole / 25-pole, 3 m................ 6.2125.020
Extension cable 9-pole / 9-pole, 3 m.................... 6.2134.110
Start TiNet on the computer and configure the Sample
Changer; see TiNet Instructions for Use.
2.6 Adjusting Sample Changer
The offset settings for new instruments are determined by
Metrohm. Each Sample Changer is supplied with a docu-
ment containing these data.
Entering the offset data in TiNet
1. Start the program "Iniedit.exe" from the TiNet bin direc-
tory.
2. Under "Various" you will find "Offset 748".
3. Enter the values for X and Y.
4. Press .
5. Close the program "Iniedit.exe" and start TiNet (again).