In the box, Iosd controller ×1, Can-bus cable ×2 – DJI iOSD MARK II User Manual

Page 4: Video input cable ×1, Video output cable ×2, Pin to 3-pin cable ×1

In the Box

iOSD Controller ×1

Connect the iOSD controller to your DJI autopilot system via

CAN-Bus Cable. It communicates with the main controller,

receives data from the main controller,

superimposes the data

with the video image, and then transmits the whole information

via a transmitter.

CAN-Bus Cable

×2

Connect the iOSD to your autopilot system through a CAN-Bus

cable.

Video Input Cable ×1

Connect the iOSD with video input source (i.e. camera or DJI

Z15) for video input and power supply, with maximum current

of 1A. If you connect the iOSD to DJI Z15, please use the 4Pin-

Audio Head cable.

If connect to other camera, use the 4Pin cable for the

connection in accordance with the wiring diagram.

Video Output Cable ×2

Only when you use the wireless video transmitter module

specified by DJI, you can use the bi-port cable to connect the

iOSD with the video transmitter module. Otherwise, you can

use the one-port cable for your own connection in accordance

with the wiring diagram.

2-PIN to 3-PIN Cable ×1

Connect the iOSD with the R/C receiver through this cable.

When there are two video signal inputs, it is used for the

selection of video signal sources. It can be used for the

selection of AVL58 video channel.