Introduction – DJI iOSD MARK II User Manual

Page 3

Introduction

DJI iOSD is specially designed for DJI autopilot system during the FPV flight or other aero-modeling activates. DJI iOSD

can transmit video and iOSD information in real time, which will help you to obtain the aircraft status information during a

FPV flight. It can display power voltage, flight velocity, height, distance from the home point, horizontal attitude, GPS

satellite number, etc. iOSD and video information are superposed on the receiver, making iOSD data clearly visible and

bringing you a more involved flight experience.

DJI iOSD should be used in conjunction with a DJI autopilot system. It supports two video input sources under PAL or

NTSC mode, which can be selected remotely by an R/C transmitter switch. The R/C TX switch can also change the

wireless video transmitter channel remotely when user uses the wireless video transmitter specified by DJI. The iOSD

supports online upgrades. The iOSD has built-in BEC, which is on one hand for the power supply of the camera, on the

other hand for the power supply of the autopilot system’s main controller to improve the power supply reliability of the

main controller.

Specified autopilot systems for the iOSD

Status

Autopilot system & Aircraft

Supported

A2, WKM, NAZA-M*, NAZA-M V2*, PHANTOM 2

Not yet supported

WKH

、ACE ONE、ACE WAYPOINT

*iOSD should be connected to the NAZA-M or NAZA-M V2 via the PMU V2 (NAZA-M V2 Accessory).

*iOSD should not be connected to the WKM and NAZA-M/ NAZA-M V2 at the same time.

*NAZA-M should be upgrade to the firmware version of V3.16 (or above), with the same assistant software V2.16 of

Naza-M V2.